Skip to main content

Replace thermal post-combustion:

There are alternatives that are more cost-effective, more flexible and
space-saving – and save 99 % CO₂ at the same time.

Replace thermal post-combustion:

There are alternatives that are more cost-effective, more flexible and
space-saving – and save 99 % CO₂ at the same time.

Clean air calls for clean solutions.

We tackle organic pollutants with clean technologies: UV ozone, plasma, electrostats, scrubbers and activated carbon are alternative technologies to thermal post-combustion with gas.

It all depends on the right sequence of process steps and the right dimensions for the load. With our 20 years of expertise in exhaust air purification, we can usually find the solution for a specific pollutant profile that will enable you to fulfil the TA Luft.

What would you like to know?

Simply put your question to our AI. They will answer you individually:

zum Chat

oxytec exhaust air purification systems are so light that they can also be placed directly above production on the roof.

Our solutions are superior to TNV in several ways

  1. On/off operation: We don’t need a pre-run.
  2. We need 80% less energy than the TNV.
  3. Our systems require very little space and can therefore be installed close to production.
  4. The installation costs are low. Maintenance costs are also low.
  5. Our system saves 99% of CO₂ compared to TNV.

We offer a solution for most organic pollutant profiles.

When coating fabrics, furniture and technical components and in the chemical and pharmaceutical industries, the exhaust air is contaminated with solvents. Around 50 substances occur relatively frequently. Because they are mostly of organic origin, we are able to get them under control with our technologies.

We also have a lot of experience with the food industry. We remove greasy exhaust air, such as that produced during frying, baking and deep-frying, immediately after the cooking process that caused it. Because our systems are extremely space-saving, we install them close to the production facilities to prevent sooting of the exhaust air ducts.

This is not possible with a thermal post-combustion system due to its dimensions alone. The exhaust air ducts that lead there must then be cleaned regularly at great expense.

Our Purification Appliances

CEA

UV ozone exhaust air purification system to meet TA Luft requirements

Exhaust air purification plant for industrial processes

CWA

Exhaust air scrubbing system, removes water-soluble and odor-bearing particles, especially ammonium

Countercurrent scrubber

KAT

Storage reactor for air post-treatment after UV ozone cleaning

Aktivkohlefilter

CSA

Automated smoke scrubber system

Smoke scrubber

AAH

Air-to-air heat recovery for the use of hot exhaust air

Heat recovery unit

7 reasons to replace the TNV now

  1. Gas is expensive and the price of gas is difficult to calculate.
  2. A TNV consumes 30% of the energy alone to keep the flame stable.
  3. A TNV cannot simply be switched on and off as required.
  4. A TNV only removes part of the odour.
  5. A TNV requires an enormous amount of space.
  6. The technical effort required for heat recovery is considerable, with corresponding system costs.
  7. A TNV generates enormous amounts of CO₂.

What would you like to know?

Simply put your question to our AI. She will answer you individually:

to chat
Chatbot Overlay

Do you have any questions or
would like a quotation?

Please contact us:

E-Mail
Phone